Dear All
If I don't have pole zero file or response file, can I use transfer command?
Thank You
Ami
If I don't have pole zero file or response file, can I use transfer command?
Thank You
Ami
-
On 09/02/2014 06:56 AM, amik Amik wrote:
Dear All
Dear Ami,
If I don't have pole zero file or response file, can I use transfer command?
Thank You
Ami
_______________________________________________
sac-help mailing list
sac-help<at>iris.washington.edu
http://www.iris.washington.edu/mailman/listinfo/sac-help
If you just want to try out the "transfer" command to see
if it works, you can use one of the built-in instruments
(see "help transfer", a long way down the help file,
for a list).
e.g "funcgen impulse <parameters>" followed by "transfer to <instrument name>"
If you really need to remove the response of your instrument
from the seismogram, then you must get a pole-zero file or
a response file for your seismometer/digitiser.
If your data are in SEED format from IRIS then if you run
"rdseed" in interactive mode and answer "yes" to the queries
"extract poles and zeros" and/or "extract response file"
then you should get poles and zeros and/or a RESP file
for your data.
If your data are from your own seismometer and
you know the make and serial number of your seismometer/digitiser,
you may be able to obtain the response from the manufacturer.
In particular, if it is a Guralp, if you send an email with
the serial number in the "Subject:" line to the address
caldoc<at>guralp.com you will receive a calibration sheet for it.
You will need to do the same for the digitiser, because the
response is a combination of the two. Again for Guralp
digitisers if you email the serial number to caldoc<at>guralp.com
you will be sent a calibration sheet. Some Guralp
seismometers have the digitiser built in, but the label should
show two serial numbers, one for the seismometer, one for the
built-in digitiser.
Regards,
Sheila Peacock,
Blacknest.
-
Yes.
**********************************
Milton P. PLASENCIA LINARES
Dipartimento Centro di Ricerche Sismologiche
Istituto Nazionale di Oceanografia e di Geofisica Sperimentale - OGS
Borgo Grotta Gigante 42/C
(34010) Sgonico - TRIESTE - ITALIA
Tel: +39-040-2140 256/141
Fax: +39-040-327307
E-mail: mplasencia<at>inogs.it
ASAIN (Antarctic Seismographic Argentinean Italian Network)
*********************************
Quoting "amik Amik" <amik.mamat<at>yahoo.co.id>:
Dear All
----------------------------------------------------------------
If I don't have pole zero file or response file, can I use transfer command?
Thank You
Ami
This message was sent using IMP, the Internet Messaging Program.