Thread: pick phases

Started: 2007-07-22 08:57:56
Last activity: 2007-07-22 08:57:56
Topics: SAC Help
Murat BEYHAN
pick phases
2007-07-22 08:57:56
Dear Friends,

I read sac data and draw by plotpk p 1
then I pick p and s arrival on the data.
But I would like to save picked data to the SAC data header.
I mean When I open the data after I save even if I close the session of SAC,
I would like to see the picked phases on the waveform.
Could you tell me How can I do this.
Regards...
Murat

--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.


  • Arthur Snoke
    Re: pick phases
    2007-07-22 02:33:42
    You must save the file after doing the picks. Either write over (which
    would replace your original file) or write file.new.

    On Sun, 22 Jul 2007, Murat Beyhan wrote:

    Dear Friends,

    I read sac data and draw by plotpk p 1
    then I pick p and s arrival on the data.
    But I would like to save picked data to the SAC data header.
    I mean When I open the data after I save even if I close the session of SAC,
    I would like to see the picked phases on the waveform.
    Could you tell me How can I do this.
    Regards...
    Murat

    --
    This message has been scanned for viruses and
    dangerous content by MailScanner, and is
    believed to be clean.

    _______________________________________________
    sac-help mailing list
    sac-help<at>iris.washington.edu
    http://www.iris.washington.edu/mailman/listinfo/sac-help


SAGE Facility has been certified as a trustworthy data repository by the CoreTrustSeal Standards and Certification Board
20:05:13 v.22510d55