Thread: SAC installation.

Started: 2013-03-31 01:48:38
Last activity: 2013-03-31 01:48:38
Topics: SAC Help
Ali Abdolali
2013-03-31 01:48:38
Dear List members.
I am a new user of SAC.
I have faced some problems during SAC installation. I am using CYGWIN on
Win7 64 bit.
after doing untar and installing following tools for CYGWIN, I run
"configure, make and make install".

Devel:
* gcc-g++
* libncurses-devel
* make
* readline
Libs:
* sunrpc
X11:
* xorg-x11-devel

then I typed X, a blank window was appeared on my screen where I
couldn't write anything. I was expecting it should be SAC. but I
cannot do anything inside it. could you please guide me how I can run
it? if there is some hints to do it or if you find my mistake, please
let me know.

I wanna use SAC in order to convert Seismographs into bottom
movement/velocity or acceleration. as far as i know, seismologists use
this package to do such a job.

thanks in advance.

regards.

Ali-





------------------------------
Ali Abdolali
PhD. Candidate, Department of Civil Engineering, University of Roma Tre
No,62, Via Vito Volterra, Rome, Italy
Tel: +39-3884781904, +39-0657333635 Fax: +39-06-57333441
website: http://www.uniroma3.it
E-mail: *aabdolali<at>uniroma3.it, <aabdolali<at>uniroma3.it>
ali_abdolali<at>aut.ac.ir, <ali_abdolali<at>aut.ac.ir>** a.abdolali<at>ptpco.com*

------------------------------

------------------------------

------------------------------

Page built 19:24:58 | v.b'59d0d2